[ Pobierz całość w formacie PDF ]
Note:
For part replacement, drill hole before painting.
- Drill 7 mm diameter hole in fender. Dimension -a- = 22mm and -b- =
8mm.
- Restore corrosion protection at edges of hole.
Fig. 3 Lower fender mount (S4)
- Slide speed nuts -4- onto door sill from bottom.
- Speed nuts -5- only for S4
- Secure fender -1- at bottom using reinforcing bracket -2- and bolts -3-.
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.BD01.50.1 11/20/2002
Body, front Page 18 of 19
50-18
Noise insulation panel, assembly overview
1 -
Quick-release screw
Remove only this quick release screw for
service position
Three pieces
2 Nm (18 in. lb)
2 -
Front noise insulation
3 -
Quick release screw
Three pieces
If rear noise insulation panel is also - 4 -
being installed, then longer quick-release
screws must be used
2 Nm (18 in. lb)
4 -
Rear noise insulation panel
Only installed for certain engine types
Installed over noise insulation panel -2-
5 -
Quick-release screw
Two pieces
2 Nm (18 in. lb)
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.BD01.50.1 11/20/2002
Body, front Page 19 of 19
50-19
6 -
Mounting for noise insulation panel
Position -9- must face left side of vehicle
7 -
Bolt
Two pieces
7.5 Nm (66 in. lb)
8 -
Plate nut
Two pieces
9 -
Plate nut
Three pieces
10 -
Clamping pin
Two pieces
11 -
Wheelhousing liner
12 -
Bumper
13 -
Lock carrier with attachments
http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.BD01.50.1 11/20/2002
[ Pobierz całość w formacie PDF ]